Zennio Z41 Manual descarregar pdf (Página 47)

ZENNiO AVANCE Y TECNOLOGÍA _vwww.zennio.com

3.4.5. TOOLS

The tools page provides access to tools that ease the Z41 programming process. Two boxes can

be enabled; Programming LED (enabled by default) and Reset. For each box it is possible to

specify a descriptive name via the parameter "Label".

Figure 3.24: Tools page configuration

Box 1 (Programming LED): When programming the Z41’s physical address, it is

possible to put the device in "programming mode" directly from this box, by pressing the right

button. This feature means that it is not necessary to access the rear of the panel to

physically push the programming button, thus simplifying the programming process. To

deactivate programming mode, press the left button.

Box 2 (Reset): This box has a single central button. To reset the Z41 it is necessary to

press the button for at least 3 seconds, until the Z41’s status page is displayed. The status

objects associated to the different pages and the configuration parameters are reset to their

default values. The time and date are unaltered. Timer configurations will be maintained,

however the timers will be deactivated e.g. the Time ON and Time OFF checkboxes will be

unchecked.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 53

Sem comentários

Zennio Z41 Manual Página 47