Zennio Z41 Manual descarregar pdf (Página 38)

ZENNiO AVANCE Y TECNOLOGÍA _vwww.zennio.com

c) Timers specific page

Note: Only specific pages 3 and 4 may be configured as Timers.

Each Timers specific page allows the configuration of up to 8 different timers. The timers

may be used to switch on or off KNX devices, or may be used to activate a scene. The

configuration of the timer is in two parts. The behavior of the timer is configured via

parameters in ETS, however the ON and OFF times and the days of the week that the timer

is active are configured by the user via the Timers Page on the Z41.

Figure 3.19: Timers specific page configuration

Each enabled timer has its own 1-bit control object: “[Timers 3 (or 4)] Timer x”, and the

following parameters can be configured:

 Label: Descriptive name used to label the timer.

 Linked to scene: When this option is enabled a scene may be executed at Time

ON, Time OFF or both depending on this configuration:

 Only for timer ON: The parameter “Scene number (ON)” will appear where the

scene number to execute at Time ON is specified.

 Only for timer OFF: The parameter “Scene number (OFF)” will appear where

the scene number to execute at Time OFF is specified.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 52 53

Sem comentários

Zennio Z41 Manual Página 38