Zennio Z41 Manual descarregar pdf (Página 30)

ZENNiO AVANCE Y TECNOLOGÍA _vwww.zennio.com

The light dimming operates as follows:

 Short press: For each short press of the left button, the value "0" will be sent to the

bus via the object "[Home x - Box y] Light On/Off" thus making the light source switch off

(if the KNX device has been configured to behave this way when receiving the value "0").

For each short press of the right button, the value "1" will be sent, thus making the light

source switch on (if the KNX light source has been configured to behave this way when

receiving the value "1").

 Long press: On a long press of the left button, the order to decrease the brightness

level by the dimming step will be sent via the object "[Home x - Box y] Light Dimming".

When the button is released, the order to stop decreasing the brightness level is sent. On

a long press of the right button, the order to increase the brightness level by the dimming

step will be sent via the object "[Home x - Box y] Light Dimming". When the button is

released, the order to stop increasing the brightness level is sent.

The object "[Home x - Box y] Light Indicator" must be linked, with the same group address, to

a status object that reflects the brightness level of the light source to control, in order to

update the percentage indicator that appears in the centre of the box with the current

brightness level.

Dimming step

Number of steps for complete

regulation (0-100%)

100%

50%

25%

12.5%

6.25%

3.1%

1.5%

Table 3.1: Dimming step

Shutter control: This control allows the Z41 to manage any type of shutter or blind. The

following objects are enabled; "[Home x - Box y] Move Shutter" and "[Home x - Box y] Stop

Shutter", 1-bit each. These objects control the raising/lowering or stopping of the shutter,

respectively. The 1-byte object "[Home x - Box y] Shutter Position" allows the shutter to

provide feedback to the Z41 of its exact position at any given moment.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 52 53

Sem comentários

Zennio Z41 Manual Página 30