Zennio Z41 Manual descarregar pdf (Página 28)

ZENNiO AVANCE Y TECNOLOGÍA _vwww.zennio.com

Enumeration: This option allows associating numerical values with texts. When

selecting it, two new 1-byte communication objects will be shown: "[Home x - Box y] 1 byte

Control" and "[Home x - Box y] 1 byte Indicator". The behavior of this type of control is as

follows:

 First configure the parameter "# Enums" the number of value-text pairs (1 to 6), and

then specify the value-text pairs using fields "Value z" and "Icon z", respectively (refer to

3.3.1).

 After downloading the desired configuration, the text displayed in the box will the one

associated with the Value 1, i.e., the text specified by the parameter (Icon 1).

 If the right button is pressed (short press), the text displayed as well as the value

sent to the bus will be the next value-text pair. When the last value-text pair is reached

the control will wrap to the first value-text pair, e.g. 2-3-4-5-6-1-2-3…

 If the left button is pressed (short press), the text displayed as well as the value sent

to the bus will be the previous value-text pair. When the first value-text pair is reached

the control will wrap to the last value-text pair, e.g. 6-5-4-3-2-1-6-5...

 The text can be modified via the KNX bus if the object "[Home x - Box y] 1 byte

Indicator" receives a value that has an text associated with it. If this object receives a

value that does not have an text associated no text will be displayed.

Note: Each value-text pair must have a unique value. It is not a valid configuration if two or

more value-text pairs share the same value, and the behavior of the control in this case is

undefined.

Integer (2 bytes): This option allows the Z41 to communicate with the rest of devices in

the installation by sending a 2-bytes value (0…65535). When selecting this option, two new 1-

byte communication objects will be shown: "[Home x - Box y] 2 byte Control" and "[Home x -

Box y] 2 byte Indicator", and the following configuration options appear:

 Initial value: The initial value of the control and indicator objects, in the range

0…65535, after downloading the configuration or a ‘reset device’.

 Minimum value: The minimum value, in the range 0…65535, that may be reached

by pressing the left button.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 52 53

Sem comentários

Zennio Z41 Manual Página 28