Zennio Z41 Manual descarregar pdf (Página 35)

ZENNiO AVANCE Y TECNOLOGÍA _vwww.zennio.com

 Heat/Cool: The climate mode may be either Heat or Cool. A short press of the

left button selects Cool mode and the value “0” is sent via the 1-bit control object

"[Climate x] Mode Control". Conversely a short press of the right button selects Heat

mode and the value “1” is sent. The climate system can provide feedback by sending

the corresponding Heat/Cool value to the 1-bit indicator object "[Climate x] Mode

Indicator". The central indicator icon will always reflect the current mode.

 Extended: In addition to the climate modes Heat and Cool, the modes, Auto,

Fan and Dry are available. Each may be enabled or disabled by checking or

unchecking its respective checkbox. By default all modes are enabled. A short press

of the left or right button will cycle through the enabled modes, and the value

associated with the current mode will be sent via the 1-byte control object "[Climate

x] Mode Control". The values associated with each mode are summarized in table

3.2:

Mode

Value

Auto

Heating

Cooling

Fan

Dry

Table 3.2: Climate mode values

The climate system can provide feedback by sending the corresponding value to the

1-byte indicator object "[Climate x] Mode Indicator". The central indicator icon will

always reflect the current mode, unless the value received by the indicator object is

not one of the values in table 3.2, in which case no icon will be displayed.

 Box 4 (Fan): The fan speed control is a "1-bit" control to request either an increase

or a decrease of the fan speed. A short press of the left button will send the value “0” via

the control object "[Climate x] Fan Control" resulting in a decrease in of the fan speed. A

short press of the right button will send the value “1” resulting in an increase in of the fan

speed. The object "[Climate x] Fan Indicator" may be used by the climate system to

provide feedback of the actual fan speed, with the central indicator icon displayed

depending on both the state of the object and on the parameter “Fan” as illustrated in

table 3.3:

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 52 53

Sem comentários

Zennio Z41 Manual Página 35