Zennio Z41 Manual descarregar pdf (Página 25)

ZENNiO AVANCE Y TECNOLOGÍA _vwww.zennio.com

Enumeration: This option allows associating numerical values with icons. When

selecting it, two new 1-byte communication objects will be shown: "[Home x - Box y] 1 byte

Control" and "[Home x - Box y] 1 byte Indicator". The behavior of this type of control is as

follows:

 First configure the parameter "# Enums" the number of value-icon pairs (1 to 6), and

then specify the value-icon pairs using fields "Value z" and "Icon z", respectively (refer to

3.3.1).

 After downloading the desired configuration, the icon displayed in the box will the

one associated with the Value 1, i.e., the icon specified by the parameter (Icon 1).

 If the right button is pressed (short press), the icon displayed as well as the value

sent to the bus will be the next value-icon pair. When the last value-icon pair is reached

the control will wrap to the first value-icon pair, e.g. 2-3-4-5-6-1-2-3…

 If the left button is pressed (short press), the icon displayed as well as the value sent

to the bus will be the previous value-icon pair. When the first value-icon pair is reached

the control will wrap to the last value-icon pair, e.g. 6-5-4-3-2-1-6-5...

 The icon can be modified via the KNX bus if the object "[Home x - Box y] 1 byte

Indicator" receives a value that has an icon associated with it. If this object receives a

value that does not have an icon associated no icon will be displayed.

Note: Each value-icon pair must have a unique value. It is not a valid configuration if two or more

value-icon pairs share the same value, and the behavior of the control in this case is undefined.

3.3.5. 2-BUTTON CONTROL AND TEXT INDICATOR

The boxes parameterized as ‘2-button control and text indicator’ will have two control buttons, one

on the left and another on the right side of the box, whose icons can be configured via the

parameters "Left Button" and "Right Button", respectively.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 52 53

Sem comentários

Zennio Z41 Manual Página 25